Set the heating time periods (if using integral programmer)
The built-in time program of the boiler needs to be enabled. This change needs to be made in the ‘Time Program service type’
section and changed from the default ‘Extended Time Program’ to ‘Program’.
‘Program’ would be used where the front display built-in timer is used for the time setting element with the 230V SwL or Volt
free On/O contacts. (Thermoregulation setting No.0 & 3, including SwL)
If the time program service type is set from ‘Extended Time Program’ to ‘Program’ you will switch from day heating line
(contact open) to night heating line (contact closed), which would mean on and o.
If the integral programmer function is not being used then is should be left as the default setting, Extended time program.
Time program / Manual
Summer / Winter / OFF
Complete Menu
Customer Complete Menu
1
Brightness in standby
Home screen timing
Home screen timing
System measurement unit
Time Program service type
Time Program service type
3
CH Settings
DHW Settings
Connectivity Settings
Screen Settings
Screen Settings
2
Scroll the wheel to select Program
and press OK to confirm selection.
4
Time Program service type
Program
Select time program service type according to
Ebus devices present in your network
35
To Next Page
Loading...
Need help?
General
