MP-1xx SIP User’s Manual 5. Configuring the MP-1xx
Version 4.4 43 March 2005
• Advanced Configuration – Use this subdivided menu to set the gateway’s advanced
configuration parameters (for advanced users only) (refer to Section 5.9 on page 103).
• Status & Diagnostics – Use this subdivided menu to view and monitor the gateway’s
channels, Syslog messages, hardware / software product information, and to assess the
gateway’s statistics and IP connectivity information (refer to Section
5.10 on page 124).
• Software Update – Use this subdivided menu when you want to load new software or
configuration files onto the gateway (refer to Section
5.11 on page 131).
• Save Configuration – Use this menu to save configuration changes to the non-volatile flash
memory (refer to Section
5.12 on page 139).
• Reset – Use this menu to remotely reset the gateway. Note that you can choose to save the
gateway configuration to flash memory before reset (refer to Section
5.12 on page 139).
When positioning your curser over a parameter name (or a table) for more than 1 second, a short
description of this parameter is displayed. Note that those parameters that are preceded with an
exclamation mark (!) are Not changeable on-the-fly and require reset.
5.7.2 Saving Changes
To save changes to the volatile memory (RAM) press the Submit button (changes to parameters
with on-the-fly capabilities are immediately available, other parameter are updated only after a
gateway reset). Parameters that are only saved to the volatile memory revert to their previous
settings after hardware reset. When performing a software reset (i.e., via Web or SNMP) you can
choose to save the changes to the non-volatile memory. To save changes so they are available
after a power fail, you must save the changes to the non-volatile memory (flash). When Save
Configuration is performed, all parameters are saved to the flash memory.
To save the changes to flash, take these 2 steps:
1. Click the Save Configuration button; the ‘Save Configuration to Flash Memory’ screen
appears.
2. Click the Save Configuration button in the middle of the screen; a confirmation message
appears when the save is complete.
Note: When you reset the MP-1xx from the Web Interface, you can choose to save the
configuration to flash memory.
5.7.3 Entering Phone Numbers in Various Tables
Phone numbers entered into various tables on the gateway, such as the Tel to IP routing table,
must be entered without any formatting characters. For example, if you wish to enter the phone
number 555-1212, it must be entered as 5551212 without the hyphen (-). If the hyphen is entered,
the entry does not work. The hyphen character is used in number entry only, as part of a range
definition. For example, the entry [20-29] means “all numbers in the range 20 to 29”.
To Next Page
Loading...
Need help?
General
