BASIC SETTINGS AND HELP FEATURE
143
6
■ Page 3
9 Upper and Bobbin Thread Sensor
Set “Upper and Bobbin Thread Sensor” to either
“ON” or “OFF”. (Refer to page 146.)
0 Machine Speaker Volume
The volume of operation sounds and alarm
sounds can be adjusted. (Refer to page 15 or 147.)
A Select to save the machine power by setting the
“Eco Mode” or the “Shutoff Support Mode” (Refer
to page 148).
B Opening Screen
The machine can be set so that the opening
screen is either displayed (“ON”) or not displayed
(“OFF”) when the machine is turned on.
C Languages
Enables the display language to be changed. The
keys and messages appear in the selected
language. (Refer to page 148.)
■ Page 4
D Light
The light can be set to be turned either on or off.
(Refer to page 14 or 149.)
E Change the screen display brightness (Refer to
page 149).
F Turn on or off the LED pointer light (Refer to
page 40).
G The Total Count counter shows the total number
of stitches sewn, and the Service Count counter
show the number of stitches that have been sewn
since the machine’s last maintenance.
H The Total Time counter shows the total amount of
time that the machine has been used, and the Trip
Time counter shows the amount of time that the
machine has been used since its last
maintenance.
Use counters G and H as a standard for performing
periodic maintenance and for receiving
maintenance for the machine.
I The “No. ##” is the number for the embroidery
machine.
J Version
Shows the version of the software installed on this
embroidery machine. (Refer to page 184.)
Details of each of the settings are described in the
following sections. After specifying the desired
settings, touch to return to the screen that
was displayed before the settings screen was
displayed.
• Check with your local authorized Brother
dealer or at “ http://support.brother.com ”
for details on available updates.
• Some settings cannot be changed while
embroidering.
To Next Page
Loading...
Need help?
General
