76
In order to prevent shrinkage of the stitching or misaligned patterns, we recommend that iron-on
stabilizer (backing) be used for embroidering.
a
Using a steam iron, affix the iron-on
stabilizer (backing) to the back of the
fabric.
1 Adhesive side of iron-on stabilizer (backing)
2 Fabric (wrong side)
• When embroidering fabric that should not be ironed
or when embroidering an area that is difficult to iron,
hoop a layer of the iron-on stabilizer (backing) under
the fabric in the embroidery frame without ironing it.
Attaching Iron-On Stabilizer (Backing) to Fabric
• When embroidering on thin or stretch fabrics, fabrics with a coarse weave or fabrics that easily allow the
stitching to shrink, be sure to use iron-on stabilizer (backing) for embroidering. If iron-on stabilizer
(backing) is not used while embroidering, the needle may bend or break or the pattern may become
misaligned.
• Use a piece of iron-on stabilizer (backing)
that is larger than the embroidery frame.
When framing the fabric in the embroidery
frame, be sure that the stabilizer (backing) is
clamped on all edges in order to prevent
wrinkles in the fabric.
1 Area of embroidery frame
2 Iron-on stabilizer (backing)
• When embroidering thin fabrics, such as
organza or lawn, use a water-soluble
stabilizer (backing). Water-soluble
stabilizers dissolve when washed, allowing
you to create beautiful embroidery that is
not stiff.
• When embroidering fabric with a nap, such
as towels or corduroy, hoop a layer of iron-
on stabilizer (backing) under the fabric in the
embroidery frame without ironing it.
• For other uses of stabilizer (backing), refer
to “Stabilizers (backing)” on page 161.
To Next Page
Loading...
Need help?
General
