168
Oiling the machine
In order to extend the life of the embroidery
machine’s parts and keep the machine operating
correctly, be sure to oil the machine before the
first time that it is used. If too little oil was applied
to the race, an error message may appear.
Afterward, put a drop of oil onto the hook once a
day before use, and put a drop of oil to the lower
needle bar felt washer every 40 to 50 hours of
machine use.
■ Oiling the race
a
Turn off the embroidery machine.
b
Open the hook cover, and remove the
bobbin case. (Refer to page 33.)
c
Rotate the handwheel to a position (U) on
the machine.
1 Handwheel
• Be sure to rotate the handwheel toward the LCD
panel (counterclockwise).
d
Put a drop of oil onto the hook.
1 Punch a small hole in oil bottle.
2 Apply oil here.
• Use a pointed object to punch a small hole in the tip
of the included oiler before using it.
e
After oiling, insert the bobbin case into the
hook, and then close the hook cover. (Refer
to page 32.)
• Unplug the power supply cord before cleaning
the machine, otherwise injuries or an electric
shock may occur.
Front angle view Side view
To Next Page
Loading...
Need help?
General
