GETTING READY
19
1
Setup location
Setup the machine in a location that meets the following requirements.
• Position machine more than 50 mm (2 inches) from the wall
• Allow sufficient space around the machine
• Place no objects within the moving range of the embroidery frame
• Set-up machine near an electrical outlet
• Use a level and stable surface, such as a desk
• Use a surface that can support the weight of the machine (about 31 kg (68 lb))
• Allow open space around the ventilation slots found on the back of the machine
747 mm
(29-13/32
inches)
More than
50 mm
(2 inches)
587 mm
(23-7/64 inches)
More than
350 mm
(13-3/4 inches)
More than
150 mm
(5-29/32 inches)
511 mm
(20-15/128
inches)
More than
150 mm
(5-29/32 inches)
• In order to prevent malfunctions or damage, do not set up the machine in a location exposed to the
following conditions.
Liquids, such as water Extreme dust
Direct sunlight Blocked ventilation slots
Insufficient space
An unstable surface
Connection to extension cords or
multiple adapters
Objects within the moving range
of the embroidery frame
Extremely high or extremely low
temperatures. The operating
environment should be between
5 °C (40 °F) and 40 °C (104°F).
• For your safety: Since the machine weighs approximately 31 kg (68 lb), do not set it up on an unstable
table or desk.
To Next Page
Loading...
Need help?
General
