Check and prepare transparencies before loading
Transparencies have a different front and back side. Make sure you load transparencies so that
the print system prints on the front side.
IMPORTANT
• Do not load transparencies while the print system is printing. This can cause a paper jam.
•
Only use transparencies intended for your print system. Other transparencies can damage the
print system.
• Only hold the edges of the sheets and avoid touching the print surface.
• When transparencies stick together, fan the stack and do not load more than 100 sheets. Use
new transparencies when a paper jam occurs.
• Immediately take printed transparencies from the output tray to avoid folded transparencies.
This can cause a paper jam.
For more information, see:
Media specifications
on page 289
Check and prepare media before loading
on page 130
Procedure
1.
Make sure the media specifications match the paper tray specifications.
Only use A4 / LTR or A4R / LTRR transparencies. (See
Paper input specifications
on page 270)
2.
Remove the packaging and check that the transparencies are in good condition.
After you finish
Tightly rewrap the remaining media in the original package, and store the package in a dry place
away from direct sunlight.
Check and prepare transparencies before loading
134 Chapter 5 - Print the jobs
imagePRESS C800 Series
To Next Page
Loading...
Need help?
General