Casio XJ-UT331X User Manual

38
The projector can be configured to prompt for input of a password immediately after power is turned
on. This prevents unauthorized use of the projector. Note the following precautions whenever you use
the password feature.
 The password feature protects against unauthorized use of the projector. Note that it is not an anti-
theft measure.
 You will need to enter the initial factory default password the first time you use the projector after
turning on the password feature. Change the initial factory default password to a different one of
your choice as soon as possible after turning on the password feature.
 The remote controller is required to input the password. Take care to avoid misplacing the remote
controller. Replace the remote controller batteries as soon as possible after they start to go low.
 When inputting the password, the remote controller ID and the projector ID must be the same, or
either the remote controller ID or projector ID must be set to “All”. For more information, see
“Configuring Remote Control ID and Projector ID Settings” (page 30).
 You will not be able to use the projector if you forget its password. We strongly suggest that you
keep a written or other type of record of the password so you can look it up when necessary.
Password Protection
To do this: Perform this operation:
Change the password 1. Press the [MENU] key to display the setup menu.
2. Select “Option Settings 1”, “Password”, and then press the [ENTER] key.
3. Enter the current password, and then press the [ENTER] key.
 The password of your projector is a sequence of remote controller key inputs. If
the projector is still protected by the factory default password, perform the key
operation shown below to enter it.
4. Use the [] key to select “Change Password”, and then press the [ENTER] key.
5. Enter a key sequence up to eight key operations long, and then press the [ENTER]
key.
 You can use any of the following keys as part of your password key sequence.
[INPUT], [MENU], [BLANK], [FREEZE], [ ], [VOLUME +], [VOLUME –],
[D-ZOOM +], [D-ZOOM –], [KEYSTONE +], [KEYSTONE –], [], [], [], [],
[TIMER], [AUTO], [ASPECT], [FUNC]
6. Re-enter the same password key sequence you entered in step 5 and then press
the [ENTER] key.
 The message “Your new password has been registered.” indicates that the
password has been changed. Press the [ESC] key.
 If the password you entered in this step is different from the one you entered in
step 5, the message “The password you input is wrong.” appears. Press the
[ESC] key to return to step 5.
Change the power on
password setting
1. Perform steps 1 through 3 under “Change the password” above and display the
Password screen.
2. After confirming that “Power On Password” is selected, use the [] and [] keys to
select either the “On” or “Off” setting.
 Changing the setting from “Off” to “On” will cause the “Prompt for password
when power is turned on?” dialog box to appear. Press the [ENTER] key to
confirm that you want to turn on power on password protection, or the [ESC]
key to exit the dialog box without changing the setting.
3. After you are finished, press the [MENU] key to exit the setup menu.
[] [] [] [] [] [] [] []

Casio XJ-UT331X Specifications

General

Brand	Casio
Model	XJ-UT331X
Category	Projector
Language	English