chapter 4000
page 9
1,2 - 2,0 t A.C.
SERVICE MANUAL
Electric
036-0410-07
4-WHEEL STEERING AXLE
I
I
I
6 daNm
12 daNm
B = 80° Standard
ANGLE MEASURED FROM THE
AXLE FRAME TO THE INTERNAL
WHEEL THROUGH A SPECIAL
DEVICE
Steering axle check
Every 1000 hours
- lubricate the steering gear joints using the appropriate grease nipples (I);
- check the steering angles.
- check and if it is necessary, adjust the wheel hub bearings.
Max steering angle (internal wheel B = 80°)
End stroke setting (adjustment):
make the cylinder reach the internal end stroke, then operate on the special screws fixing
them on the spindles. Then screw in the adjust screws until you obtain the desired steering
angle B = 80°
If any abnormal consumption of the wheel tread is observed, the following controls should be
performed:
- check the parallelism of the steered wheels;
- check that the steering angle of the wheels is the same in both directions.
To Next Page
Loading...
Need help?
General
