2 . INTRODUCTION - SAFETY INSTRUCTIONS AND WARRANTY
2.12
Challenger MT500B EU
2.16.4 - Follow recommended start-up procedures
Follow the start-up procedures recommended in the Oper-
ation chapter of this Operator instruction Book. This chap-
ter includes normal starting, cold starting, and the use of
starting fluids.
2.16.5 - Controls test
After starting, check all gauges and lights again. Make sure
everything is functioning correctly. If the tractor does not
respond correctly when each control is operated, DO NOT
USE the machine until the fault is remedied.
Ensure that the starter solenoid cover is always in position.
2.16.6 - Starting fluid
WARNING: It is very important that you read
and follow the starter fluid instructions before
using it. DO NOT use aerosol cans of starter
fluid on tractors with the thermostat con-
nected to the electrical system. Ether combined with
thermostat can cause an explosion with damage to
engine, personal injury, or both.
Handle starting fluid correctly. Starting fluid must only be
used in conjunction with an ether-start aid fitted as original
equipment by the manufacturer or installed by a Dealer as
an accessory. In cases of tractors being fitted with glow
plugs or a thermostat, these must be removed prior to the
installation of an ether-start aid (Fig. 9).
If aerosol cans of starting fluid are to be used the thermo-
stat must be disconnected. Remove the wire from the
thermostat which will be found on the manifold. Tape the
end of the wire to prevent an electrical short circuit.
2.17 - WORKING SAFELY
WARNING: An unbalanced tractor could over-
turn and cause injury or death.
Make sure front frame counterweights, wheel
weights and wheel ballast are used as recom-
mended by the manufacturer. DO NOT add extra coun-
terweights to compensate for an overloaded tractor; it
is recommended to reduce the load. Keep all parts of
your body inside the cab while operating the tractor.
2.17.1 - Make the right moves
Ensure that the tractor is ready for the work to be carried
out. Make sure you know the tractor nominal load capaci-
ties and never exceed them. Be certain that any attach-
ments or implements you intend to use DO NOT EXCEED
the load rating of your tractor. Be sure the tractor and im-
plement PTO speed match.
Keep in mind that tractors normally operate on uneven, un-
paved, and often bumpy or sloping surfaces. Operating
conditions can reduce the amount of weight you should
carry or pull.
2.17.2 - Safety instructions to be observed
• Operate the controls smoothly - don’t jerk the steering
wheel or other controls.
• NEVER get on or off a moving tractor. Keep a firm grip
on the steering wheel at all times, with the thumbs clear
of the spokes when driving the tractor.
• Make sure you have adequate clearance in all directions
for the tractor and implement.
• DO NOT play with a tractor or equipment. Use only for
intended purpose.
• DO NOT attempt to work the controls except from the
driver’s seat.
Z2-535-05-03
Fig. 8
Fig. 9
WC1952
To Next Page
Loading...
Need help?
General
