Challenger Techstar CVT MT565B User Manual

5 . MAINTENANCE AND ADJUSTMENTS
5.6
Challenger MT500B EU
5.2 - SERVICE GUIDE
SERVICE GUIDE
Visits according to Service Record Book
50h 400h 800h 1200h 2000h
Engine, fuel and cooling systems
1. Change engine oil and filter(s). zzzz
2. Change fuel filter element(s). z z z z z
3. Change fuel pre filter element. zzzzz
4. Check idle speed and fuel cut off mechanism. z z z z
5. Check tension and condition of alternator/fan belt(s). zzzzz
6. Clean fuel lift pump strainer (CAT). z z z z
7. Check/Clean dry air filter element(s). zzz z
8. Change air filter elements. z
9. Check radiator coolant level. zzz z
10. Drain, flush and refill radiator with coolant. z
11. Clean main radiator and all other cooler element fins. zzzz
12. Clean air conditioning condenser. z z z z
13. Change air conditioning receiver drier. z
14. Check tension and condition of air conditioning compressor belt. z z z z z
15. Observe level of smoke emission from exhaust. zzzz
Electrical system and instruments
16. Check battery condition and electrolyte level. zzzzz
17. Check tightness of battery connections and battery safety. z z z z z
18. Check all safety start switches for correct operation. zzzzz
19. Check all indicator lights, sound alarms and instruments for correct operation. z z z z z
20. Check correct operation and adjustment of all lights. zzzzz
21. Check all other electrically powered devices (e.g. cab heater / fans, radio, wipers,
etc…) for correct operation.
z z z z z
22. Check all electronically controlled systems for correct operation. zzzzz
23. Reset the Maintenance parameters on the Datatronic. z z z z z
24. Check multi-pin "Deutsch" connectors for moisture and repack with SGB grease
if necessary.
zzzz
Front axle and steering
25. Check oil level in front axle and epicyclic drive units (4WD). zz
26. Change oil in front axle and epicyclic drive units (4WD). z z
27. Check front wheel hub / steering pivots / suspension clearance. zzzz
28. Grease drive shaft / front axle universal joints (4WD). z z z z z
29. Lubricate the steering pivots / suspended front axle. zzzzz
30. Check steering for correct operation (with & without engine running). z z z z
31. Check steering and toe-in adjustment (including tyre wear and damage). z
32. Calibrate suspended front axle. z
Transmission and hydraulics
33. Check transmission / auxiliary hydraulic oil level. Every day
34. Change transmission oil.
z
35. Change transmission suction strainer. z
36. Check oil level in the rear final drive units. zzz
37. Change the oil in the rear final drive units. z z
38. Change the 15 micron filter (Dyna VT auxiliary hydraulics). zzzzz
39. Change the transmission oil 10 micron high pressure filter element z z - z z
40. Change the oil in the auxiliary hydraulics circuit. z
41. Change the 40 micron high pressure steering filter. z
42. Change 10 micron breather (Dyna VT auxiliary hydraulics). zzzz
43. Lubricate the linkage shaft and top up only if not properly sealed. z z
44. Check automatic pick-up hitch for correct operation. zz
Clutches and Brakes
45. Check operation of the clutch pedal and transmission. zzzzz
46. Check the clutch liquid level. z z z z
47. Change the clutch liquid / bleed the circuit. z

Challenger Techstar CVT MT565B Specifications

General

Brand	Challenger
Model	Techstar CVT MT565B
Category	Tractor
Language	English