Cisco 7600 Series Module Guide

1-10
Cisco 7600 Series Router Module Guide
OL-9392-05
Chapter 1 Modules Overview
Gigabit Interface Converters
SFP Optical Transceiver Modules
Small Form-Factor Pluggable (SFP) optical transceiver modules are hot-pluggable and field-replaceable,
and you can insert them into SFP module slots on the front panel of the Supervisor Engine
720 and the
WS-X6724-SFP Gigabit Ethernet module. The SFP optical transceiver modules use an LC connector.
You can use any combination of SFP modules that your Cisco device supports. The only restrictions are
that each SFP port must match the wavelength specifications on the other end of the cable and that the
cable must not exceed the stipulated cable length for reliable communications.
Figure 1-10 SFP Optical Transceiver Module
Ta b l e 1-4 CWDM GBICs
Model Number CWDM GBIC Wavelength
CWDM-GBIC-1470= 1470 nm laser, single mode
CWDM-GBIC-1490= 1490 nm laser, single mode
CWDM-GBIC-1510= 1510 nm laser, single mode
CWDM-GBIC-1530= 1530 nm laser, single mode
CWDM-GBIC-1550= 1550 nm laser, single mode
CWDM-GBIC-1570= 1570 nm laser, single mode
CWDM-GBIC-1590= 1590 nm laser, single mode
CWDM-GBIC-1610= 1610 nm laser, single mode
63066

Cisco 7600 Series Specifications

General

Brand	Cisco
Model	7600 Series
Category	Network Router
Language	English