2-4
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
OL-1375-03
Chapter 2 Preparing for Installation
System Requirements
System Requirements
In addition to the items shipped with the client adapter, you will also need the following in order to install
and use the adapter:
• One of the following Windows CE devices equipped with a Type II or Type III PC card slot:
–
Pocket PC (PPC) running Windows CE 3.0 with an ARM, StrongARM, MIPS, SH3, or X86
processor
–
Handheld PC (HPC) running Windows CE 3.0 with an ARM, StrongARM, MIPS, SH4, or X86
processor
–
A computing device running Windows CE .NET 4.0 or 4.1 with an ARM, StrongARM, or X86
processor
Note ViewSonic devices running Windows CE .NET are not supported.
Note All drivers and supporting software (Card and Socket Services) for the PC card slot must be
loaded and configured.
• Laptop or PC with a CD-ROM drive and running a Windows operating system and ActiveSync
• Serial or USB connection to the Windows CE device
• A PPC 2002 device, if your wireless network uses EAP-TLS or PEAP authentication
• Certificate Authority (CA) and user certificates for EAP-TLS authentication or CA certificate for
PEAP authentication
• If your wireless network uses PEAP authentication with a One-Time Password (OTP) user database:
–
The hardware token from an OTP vendor
–
Your hardware token password
• The following information from your system administrator:
–
The logical name for your Windows CE device (also referred to as client name)
–
The case-sensitive service set identifier (SSID) for your RF network
–
The primary and secondary Domain Name System (DNS) and Windows Internet Name Service
(WINS) to be assigned to your Windows CE device
–
If your Windows CE device is not connected to a DHCP server, the IP address, subnet mask,
and default gateway address to be assigned to your device
–
The wired equivalent privacy (WEP) keys of the access points with which your client adapter
will communicate, if your wireless network uses static WEP for security
–
Your username and password for LEAP or PEAP authentication, if your wireless network uses
one of these authentication types
–
Your username for EAP-TLS authentication, if your wireless network uses EAP-TLS
authentication
To Next Page
Loading...
Need help?
General
