5-22
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
OL-1375-03
Chapter 5 Configuring the Client Adapter
Using Host-Based EAP
Enabling PEAP
Follow the steps below to enable PEAP for this profile.
Step 1 For EAP Type, select Cisco PEAP or PEAP. If you select Cisco PEAP, go to Step 2. If you select PEAP,
go to Step 8.
Note PEAP appears as an EAP Type option on a PPC 2002 device if the Microsoft PEAP
supplicant (rather than the Cisco PEAP supplicant) was installed.
Step 2 Tap the Properties button. The PEAP Properties screen appears (see Figure 5-8).
Figure 5-8 PEAP Properties Screen
Step 3
Make sure that the Validate server certificate check box is checked if server certificate validation is
required (recommended).
Step 4 If you want to specify the name of the server to connect to, check the Connect only if server name ends
in check box and enter the appropriate server name suffix in the field below.
Note If you enter a server name and the client adapter connects to a server that does not match the
name you entered, you are prompted to accept or cancel the connection during the authentication
process.
Note If you leave this field blank, the server name is not verified, and a connection is established as
long as the certificate is valid.
To Next Page
Loading...
Need help?
General
