Cisco Catalyst 3650 Series Hardware Installation Guide

CHAPTER
5-1
Catalyst 3650 Switch Hardware Installation Guide
OL-29734-01
5
Troubleshooting
This chapter includes the following topics:
• Diagnosing Problems, page 5-1
• Resetting the Switch, page 5-5
• Finding the Switch’s Serial Number, page 5-6
• Replacing a Failed Data Stack Member, page 5-6
Diagnosing Problems
The switch LEDs provide troubleshooting information about the switch. They show power-on self-test
(POST) failures, port-connectivity problems, and overall switch performance. You can also get statistics
from the CLI, or a Simple Network Management Protocol (SNMP) workstation. For details, refer to one
of the following guides:
• Cisco Catalyst 3650 Series Switches Software Configuration Guides at
http://www.cisco.com/c/en/us/support/switches/catalyst-3650-series-switches/products-installation
-and-configuration-guides-list.html
• Cisco Catalyst 3650 Series Switches Command Reference Guides at
http://www.cisco.com/c/en/us/support/switches/catalyst-3650-series-switches/products-command-
reference-list.html
• The documentation that came with your SNMP application
Switch POST Results
Approximately 30 seconds after the switch powers on, it begins the POST, which can take up to 5
minutes to complete. During POST, the SYSTEM LED blinks green. After POST is complete, the
SYSTEM LED turns solid green. The ACTV LED is green if the switch is acting as the active switch.
Caution POST failures are usually fatal. Contact your Cisco technical support representative if your switch does
not pass POST.

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English