Cisco Catalyst 3750-X User Manual

14-3
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 14 Configuring Auto Smartports Macros
Configuring Auto Smartports
Figure 14-1 Cisco Medianet Deployment Example
Configuring Auto Smartports
• Default Auto Smartports Configuration, page 14-3
• Auto Smartports Configuration Guidelines, page 14-4
• Enabling Auto Smartports, page 14-5
• Configuring Auto Smartports Default Parameter Values, page 14-6
• Configuring Auto Smartports MAC-Address Groups, page 14-7
• Configuring Auto Smartports Macro Persistent, page 14-8
• Configuring Auto Smartports Built-In Macro Options, page 14-9
• Creating User-Defined Event Triggers, page 14-11
• Configuring Auto Smartports User-Defined Macros, page 14-15
Default Auto Smartports Configuration
• Auto Smartports is disabled globally and enabled per interface.
• CDP fallback is disabled globally and enabled per interface.
• Cisco IOS shell is enabled.
• Auto Smartports macros are used by default when ASP is enabled for the devices shown in
Table 14-1.
Auto Smartports macro
configuration applied to the port
Switch with Auto
Smartports enabled
Device Identified through CDP, 802.1x,
MAB, LLDP, MAC address, or OUI
206545
Ta ble 14-1 Auto Smartports Built-In Macros
Macro Name Description
CISCO_PHONE_AUTO_
SMARTPORT
This macro applies the IP phone macro for Cisco IP phones. It enables QoS, port-security,
sto
rm-control, DHCP snooping, and spanning-tree protection. It also configures the access and
voice VLANs for that interface.
CISCO_SWITCH_AUTO_
SMARTPORT
This macro applies the switch macro for Cisco switches. It enables QoS and trunking with
80
2.1Q encapsulation. It also configures the native VLAN on the interface.

Cisco Catalyst 3750-X Specifications

General

Brand	Cisco
Model	Catalyst 3750-X
Category	Switch
Language	English