Cisco Catalyst 3750-X User Manual

15-30
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 15 Configuring VLANs
Configuring VMPS
Beginning in privileged EXEC mode, follow these steps to change the reconfirmation interval:
To return the switch to its default setting, use the no vmps r
econfirm global configuration command.
Changing the Retry Count
Beginning in privileged EXEC mode, follow these steps to change the number of times that the switch
attempts to contact the VMPS before querying the next server:
To return the switch to its default setting, use the no vmps r
etry global configuration command.
Monitoring the VMPS
You can display information about the VMPS by using the show vmps privileged EXEC command. The
switch displays this information about the VMPS:
• VMPS VQP Version—the version of VQP used to communicate with the VMPS. The switch queries
the VMPS that is using VQP Version 1.
• Reconfirm Interval—the number of minutes the switch waits before reconfirming the
VLAN-to-MAC-address assignments.
• Server Retry Count—the number of times VQP resends a query to the VMPS. If no response is
received after this many tries, the switch starts to query the secondary VMPS.
• VMPS domain server—the IP address of the configured VLAN membership policy servers. The
switch sends queries to the one marked current. The one marked primary is the primary server.
• VMPS Action—the result of the most recent reconfirmation attempt. A reconfirmation attempt can
occur automatically when the reconfirmation interval expires, or you can force it by entering the
vmps reconfirm privileged EXEC command or its Network Assistant or SNMP equivalent.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
vmps reconfirm minutes Enter the number of minutes between reconfirmations of the dynamic
VLAN membership. The range is 1 to 120. The default is 60 minutes.
Step 3
end Return to privileged EXEC mode.
Step 4
show vmps Verify the dynamic VLAN reconfirmation status in the Reconfirm Interval
field of the display.
Step 5
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
vmps retry count Change the retry count. The retry range is 1 to 10; the default is 3.
Step 3
end Return to privileged EXEC mode.
Step 4
show vmps Verify your entry in the Server Retry Count field of the display.
Step 5
copy running-config startup-config (Optional) Save your entries in the configuration file.

Cisco Catalyst 3750-X Specifications

General

Brand	Cisco
Model	Catalyst 3750-X
Category	Switch
Language	English