Cisco cBR Series Hardware Installation Guide

Figure 90: Routing the Fiber-Optic Cables Connected to the Supervisor PIC—Option 3
Cable tie3Strap-down clip1
Supervisor PIC cable management bracket4Fiber-optic cable bundle in flexible conduit2
Step 2 Perform the following for the RJ-45 cables connected to the Supervisor PIC:
• If you are using a chassis-mounted snap-on plastic fiber/cable routing guide, route the RJ-45 cables through the
lower slot of the snap-on plastic fiber/cable routing guide and then through the lower slot of the Supervisor PIC
cable management bracket. Secure the cable bundle using cable ties.
• If you are using a chassis-mounted cable strap-down clip without the snap-on plastic fiber/cable routing guide, route
the RJ-45 cables through the lower slot of the Supervisor PIC cable management bracket. Secure the cable bundle
to the lower tie down point on the strap-down clip using a cable tie.
The following figures illustrate the possible cable routing options for the RJ-45 cables connected to the Supervisor PIC:
Cisco Converged Broadband Routers Hardware Installation Guide
127
Installing the Supervisor in the Cisco cBR Chassis
Cable Management for the Supervisor PIC in the Cisco cBR Chassis

Cisco cBR Series Specifications

General

Brand	Cisco
Model	cBR Series
Category	Network Router
Language	English