Cisco cBR Series Hardware Installation Guide

Supervisor PIC cable management bracket4Strap-down clip1
Snap-on plastic fiber/cable routing guides5RJ-45 cable bundle2
—Cable tie3
Figure 93: Routing the RJ-45 Cables Connected to the Supervisor PIC—Option 3
Cable ties3Strap-down clips1
Supervisor PIC cable management bracket4RJ-45 cable bundle2
Step 3 Repeat Step 1, on page 102 and Step 2, on page 104 for the cables connected to the each Supervisor PIC.
Using the USB Port on the Supervisor Card
Before you begin
• Install the Supervisor PIC.
• Install the Supervisor Card.
Restrictions
The USB ports on the Supervisor Card are used for temporary connections. For all permanent connections,
you must use the ports on the Supervisor PIC.
Required Tools and Equipment
Cisco Converged Broadband Routers Hardware Installation Guide
129
Installing the Supervisor in the Cisco cBR Chassis
Using the USB Port on the Supervisor Card

Cisco cBR Series Specifications

General

Brand	Cisco
Model	cBR Series
Category	Network Router
Language	English