Figure 141: Opening the Ejector Levers of the PIC
Figure 142: Removing the PIC from the Chassis
Step 3 Place the removed card in an antistatic bag.
What to do next
• Replace with RF Through PIC, RF Protect PIC or PIC Blank.
Removing the cLGA Connector from an Interface Line Card
The cLGA 10 X 22 Position .050 C/L Connector (cLGA connector) must be removed only in case of a failure
or fault.
Cisco Converged Broadband Routers Hardware Installation Guide
219
Maintaining the Interface Cards in the Cisco cBR Chassis
Removing the cLGA Connector from an Interface Line Card
To Next Page
Loading...
Need help?
General
