Figure 148: Removing the Interface Card from the Slot
Step 4 Grasp the faceplate of the card with one hand and place your other hand under the card to support its weight, and remove
the card from its slot.
Step 5 Place the removed card in an antistatic bag.
If a line card blank is removed, it need not be placed in an antistatic bag.
Note
Close the spring-loaded ejectors before placing it in the anti-static bag.
Note
What to do next
• Replace the Interface Line Card or install a line card blank (as required).
Removing the Digital PIC from the Cisco cBR Chassis
Before you begin
• Before removing an Digital PIC, ensure that one of the following cards is available for immediate
replacement in the chassis:
• replacement Digital Through PIC or Digital Protect PIC
• PIC Blank
Cisco Converged Broadband Routers Hardware Installation Guide
225
Maintaining the Interface Cards in the Cisco cBR Chassis
Removing the Digital PIC from the Cisco cBR Chassis
To Next Page
Loading...
Need help?
General
