Cisco DX650 User Manual

Speakerphone
If the handset is in its cradle and is not lit, many actions that you take to dial a number or answer a call
trigger speakerphone mode automatically.
Speakerphone is unavailable while headphones, or a headset with an incompatible microphone, are plugged
in.
Then...If you want to...
Press .
Toggle speakerphone mode on or off
Lift the handset.Switch to a handset
Press during a call or after invoking a dial tone.
Adjust the volume level for a call
AutoAnswer with headset or speakerphone
When AutoAnswer is enabled, your phone answers incoming calls automatically after a few rings. Your
system administrator configures AutoAnswer to use either the speakerphone or a headset. You may want to
use AutoAnswer if you receive a high volume of incoming calls.
Then...If you...
Keep headset mode active (in other words, keep lit), even when you are not on
a call.
To keep headset mode active, perform the following actions:
•
Press EndCall to hang up.
•
Press New Call or Dial to place new calls.
If your phone is set up to use AutoAnswer in headset mode, calls are automatically
answered only if is lit.
Otherwise, calls ring normally and you must answer them manually.
Use AutoAnswer
with a headset
Keep the handset in the cradle and headset mode inactive ( unlit).
Otherwise, calls ring normally and you must answer them manually.
Use AutoAnswer
with the
speakerphone
AutoAnswer is disabled when the Do Not Disturb feature is active.Note
Cisco Desktop Collaboration Experience DX600 Series User Guide, Release 10.0(1)
8 OL-28931-01
Phone features
Speakerphone

Cisco DX650 Specifications

General

Brand	Cisco
Model	DX650
Category	IP Phone
Language	English