Cisco XR 12000 Command Reference

show controllers pse qfp system state
To display packet switching engine (PSE) QFP HA state information for a specific node, use the show
controllers pse qfp system state command in EXEC mode.
show controllers pse qfp system state [location node-id]
Syntax Description
(Optional) Identifies the location of the node whose PSE device information you
want to display. The node-id argument is expressed in the rack/slot/module notation.
Use the show platform command to see the location of all nodes installed
in the router.
Note
location node-id
Command Default
None.
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
Task ID
OperationsTask ID
readinterface
readcisco-support
Examples
The following command shows how to run the show controllers pse qfp system state command:
RP/0/0/CPU0:router# show controllers pse qfp system state location 0/1/cpu0
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 4.3.x
28 OL-28456-02
ASIC Driver Commands
show controllers pse qfp system state

Cisco XR 12000 Specifications

General

Brand	Cisco
Model	XR 12000
Category	Network Router
Language	English