Cisco XR 12000 Command Reference

show controllers fabricq registers
To display the hardware registers of the chopper and assembler FPGAs, use the show controllers fabricq
registers command in administration EXEC mode.
show controllers fabricq registers [detail] [location node-id]
Syntax Description
(Optional) Displays detailed statistical information.detail
(Optional) Displays statistical information for the designated node. The
node-id argument is entered in the rack/slot/module notation.
location node-id
Command Default
Information for all route processors (RPs) on the router is displayed
Command Modes
Administration EXEC
Command History
ModificationRelease
This command was introduced.Release 3.2
Usage Guidelines
Use the show controllers fabricq registers command to display the hardware registers of the chopper and
assembler FPGAs. Specifying a location displays information only if that location is an RP.
This command is intended for use while performing debugging procedures.
Task ID
OperationsTask ID
read, writeroot-system
Examples
The following is sample output from the show controllers fabricq registers command for location 0/1/CPU0:
RP/0/0/CPU0:router# admin
RP/0/0/CPU0:router(admin)# show controllers fabricq registers location 0/1/CPU0
Location 0/1/0:
Chopper Registers:
------------------
FPGA Version 00020012
HP Descriptor fetch enable 00010000
Descriptor array size 000003FF
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 4.3.x
OL-28456-02 115
Fabric Management Commands
show controllers fabricq registers

Cisco XR 12000 Specifications

General

Brand	Cisco
Model	XR 12000
Category	Network Router
Language	English