Cisco XR 12000 Command Reference

show controllers plim asic ingress-channel bay
To display statistical information for the SPI4.2 receive channel on a physical layer interface module (PLIM)
ASIC, use the show controllers plim asic ingress-channel bay command in EXEC mode.
show controllers plim asic ingress-channel bay {0| 1} channel channel_number [location node-id]
Syntax Description
Displays statistical information for the SPI4.2 receive channel that is located in the
bottom bay.
0
Displays statistical information for the SPI4.2 receive channel that is located in the
top bay.
1
Identifies the receive channel whose statistics you want to display. Replace the
channel_number argument with the number of the channel whose statistics you
want to display. Range is from 1 through 255.
channel
channel_number
Identifies the location of the PLIM whose ASIC information you want to display.
The node-id argument is expressed in the rack/slot/module notation.
Use the show platform command to see the location of all nodes installed
in the router.
Note
location node-id
Command Default
No default behavior or values
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.2
The show controllers plim asic rx-channel baycommand was replaced
by the show controllers plim asic ingress-channel bay command.
Release 3.5.0
Usage Guidelines
Task ID
OperationsTask ID
readinterface
readroot-system
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 4.3.x
4 OL-28456-02
ASIC Driver Commands
show controllers plim asic ingress-channel bay

Cisco XR 12000 Specifications

General

Brand	Cisco
Model	XR 12000
Category	Network Router
Language	English