9NX501E/NZ501E
English
English
Owner’s Manual
Handling
• New discs may have some roughness around the
edges. If such discs are used, the player may not
work or the sound may skip. Use a ball-point pen or
the like to remove any roughness from the edge of
the disc.
Ball-point pen
Roughness
• Never stick labels on the surface of the disc or mark
the surface with a pencil or pen.
• Never play a disc with any cellophane tape or other
glue on it or with peeling off marks. If you try to play
such a disc, you may not be able to get it back out
of the DVD player or it may damage the DVD player.
• Do not use discs that have large scratches, are
misshapen, cracked, etc. Use of such discs may
cause misoperation or damage.
• To remove a disc from its storage case, press down
on the center of the case and lift the disc out,
holding it carefully by the edges.
• Do not use commercially available disc protection
sheets or discs equipped with stabilizers, etc. These
may damage the disc or cause breakdown of the
internal mechanism.
Storage
• Do not expose discs to direct sunlight or any heat
source.
• Do not expose discs to excess humidity or dust.
• Do not expose discs to direct heat from heaters.
Cleaning
• To remove fingermarks and dust, use a soft cloth
and wipe in a straight line from the center of the disc
to the circumference.
• Do not use any solvents, such as commercially
available cleaners, anti-static spray, or thinner to
clean discs.
• After using special disc cleaner, let the disc dry off
well before playing it.
On Discs
• Exercise a good precaution when loading a disc. The
operation panel will close automatically when leaving
it open for a while.
• Never turn off the power and remove the unit from
the car with a disc loaded.
CAUTION
For your safety, the driver should not
insert or eject a disc, opening the
operation panel while driving.
Handling Discs
To Next Page
Loading...
Need help?
General
