114
DCS-2100 User’s Manual
D-Link Systems, Inc.
Using IP Surveillance Software
The supported “Play” button is an intelligent play user-interface.
The functionality of this button can vary to fit different
circumstances. In the normal display mode, clicking on the
“Play” button can restart the displaying video sequence.
When you want to stop the displaying video sequence, you
can click on the “Stop” button. Note that once you press the
“Stop” button, the start point will be reset to the start of the
present period.
The “Pause” button provides you a way to pause the video
sequence display. When the displaying video is paused, click
on the “Pause” button again to resume the video display.
This button is only valid when the displaying video sequence
is paused. It will display the next frame in that period when you
click on the “Forward” button one time.
The camera supports a maximum of x16 fast forward play and
minimum of /16 slow forward play. This function helps you
browse the surveillance database with more flexibility. If you
want to change the playing speed, you just need to move the
speed indicator. To increase playing speed, move the indicator
in the clockwise direction. And to decrease playing speed, move
it in the counterclockwise direction. The current speed that is
set will be shown in the second column of status area.
Play Control
For the play control, the jog dial, shown in the figure below, is used to provide the
easiest method of controlling the video sequence display. All buttons can control the
displaying frame in the normal display mode.
Play:
Stop:
Pause/Resume:
Forward:
Fast Play and
Slow Play:
To Next Page
Loading...
Need help?
General