86
DCS-2100 User’s Manual
D-Link Systems, Inc.
Using IP Surveillance Software
Alert Settings
Specific alert actions can be performed by setting the options in this window.
Enable digital
input:
Digital input alert:
Recording Settings
Once the automatic video recording has been activated, you
can change this setting to regulate the recording of triggered
events. Recording will start from the specified number of
seconds before the alert event has been invoked.
Recording will last for the specified number of seconds after
the alert event has been invoked.
You can specify which media type you want to record: Video,
Audio, or both.
Record # secs.
after event:
Media Type:
Enable motion
detect:
Record # secs.
before event:
Changing the Camera Order in the List
You can “drag and drop” in the grid area of the camera list to change the sequence of
the connected Network Cameras, which is shown below. This will allow you to rearrange
the cameras in an order of your choice. Once the camera is moved to a specified location,
the proceeding cameras will then move 1 position up or 1 position down depending on
which direction the selected camera was moved.
This will trigger an alert sound that has been specified in the
section titled “Global Settings \ Alert Sound.” Check this option
to enable audio alerts for the selected camera.
This function is similar to “Enable Motion Detect” mentioned
above. Once this option has been checked, a digital input device
will be able to trigger an alert sound and recording.
This application software provides options for you to define the
triggering criteria for the digital input of the DCS-2100. The alert
of the digital input can be defined as high-level triggered or
low-level triggered.
To Next Page
Loading...
Need help?
General