82
DCS-2100 User’s Manual
D-Link Systems, Inc.
Using IP Surveillance Software
The Admin Privilege
In the Monitor program, the admin has the right to access the DCS-2100 Network Camera
through this application software and change the local settings as well. But the admin
password for the software is not the same as the admin password for the Internet camera.
You can change the settings of each selected Internet camera from the Monitor program
only if you have the admin password for the Internet camera.
If you have the admin privilege, you have the right to do the following tasks:
Again, if you need to change the settings of the DCS-2100, you must have the
administrator’s password for the camera itself.
Camera Configurations
When you log in for the first time, you should configure this application software to
connect the DCS-2100 in “Configuration Menu > Camera Configurations”, shown in
the figure below. You will need the admin (administrator) password of the camera in
order to run the configuration.
Once you click “Configuration Menu > Camera Configurations” for setting each
camera, all recording processes will be stopped indicated by a warning window popped
up in advance to keep you informed.
Run the configuration tool
Change the recording schedule
Change the local settings
To Next Page
Loading...
Need help?
General