D-Link ShareCenter DNS-340L User Manual

241D-Link ShareCenter DNS-340L User Manual
Section 4 - Conguration
USB Devices
UPS Settings
Network UPS is a system management feature that uses a local UPS to protect your NAS from an abnormal shutdown due to
a power failure.
To enable Network UPS to your NAS (Network Slave Mode):
1. Click to enable the Network UPS.
2. Enter an IP address of the Network UPS Master.
3. Click Save Settings to receive the critical power status from the
network UPS master.
The UPS Status will display the current status of your UPS.
Note: Make sure that the ShareCenter is in the same network as the network
UPS master.
If a UPS device is connected to the USB port on your NAS, you can select
either Stand-Alone or Master mode. If you select Master mode, you will have
to enter the IP address(es) of the network UPS slaves to notify them in the
event of a power failure. For more details, refer to ”UPS Connectivity” on page
433.

D-Link ShareCenter DNS-340L Specifications

General

Brand	D-Link
Model	ShareCenter DNS-340L
Category	Network Hardware
Language	English