Danfoss VLT AutomationDrive FC 300 Series Service Guide

10.2.3 Power Card Mounting Plate
The power card can remain attached when the power card mounting plate is removed from the drive. To remove the power
card mounting plate with the card attached, use the following steps. Refer to Illustration 10.2.
To remove the power card from the plate, refer to chapter 10.2.4 Power Card.
The IP20 enclosure has a dierent type and number of fasteners.
Disassembly
1. Remove the control card mounting plate. Refer to
chapter 10.2.2 Control Card and Control Card
Mounting Plate.
2. Unplug the following power card connectors:
2a MK101
2b MK103
2c MK501
2d MK502
2e MK902
2f Any wiring at MK500 and MK 106
3. Remove 4 screws (T20), 1 from each corner of the
mounting plate.
4. Remove 1 screw (T25) from the top center of the
mounting plate.
5. Free the cables from the retaining clips on the
plate.
6. Lift the power card mounting plate from the
drive.
Reassembly
Tighten hardware according to chapter 14.1 Fastener Torque
Ratings.
1. Position the power card mounting plate in the
drive.
2. Secure 1 screw (T25) in the top center of the
mounting plate.
3. Secure 4 screws (T20), 1 in each corner of the
mounting plate.
4. Attach the following power card connectors:
4a MK101
4b MK103
4c MK501
4d MK502
4e MK902
4f Any wiring at MK500 and MK106
5. Route the cables through the retaining clips.
6. Replace the control card mounting plate. Refer to
chapter 10.2.2 Control Card and Control Card
Mounting Plate.
D1h/D3h/D5h/D6h/J8 Drive Di...
VLT
®
FC Series, D1h–D8h, Da2/Db2/Da4/Db4, E1h–E4h, J8/J9
132 Danfoss A/S © 02/2019 All rights reserved. MG94A502
1010

Danfoss VLT AutomationDrive FC 300 Series Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300 Series
Category	DC Drives
Language	English