Danfoss VLT AutomationDrive FC 300 Series Service Guide

13.2.8 SCR/Diode Modules
E1h–E4h drives have 3 SCR/diode modules. To remove or
reinstall an SCR/diode module, use the following steps.
Refer to Illustration 13.7.
Disassembly
1. Remove the inrush card frame and rectier bus
plates. Refer to chapter 13.2.7 Inrush Card Frame
and Rectier Bus Plates.
2. Remove the input plate option. Refer to
chapter 13.2.10 Split Input Plate with Options.
3. Remove 1 screw (T40), which connects the SCR
input busbar to the SCR.
4. Remove 1 nut (8 mm) from the SCR input busbar.
Remove the busbar from the drive.
5. Disconnect the cable from the SCR/diode module.
6. Remove 4 screws (T25), 1 from each corner of the
SCR/diode module.
7. Remove the SCR/diode module from the drive.
Reassembly
For reassembly, use the SCR/diode module spare part
instructions that come with the parts kit.
E1h–E4h Drive Disassembly a... Service Guide
MG94A502 Danfoss A/S © 02/2019 All rights reserved. 273
13 13

Danfoss VLT AutomationDrive FC 300 Series Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300 Series
Category	DC Drives
Language	English