Danfoss VLT AutomationDrive FC 300 Series Service Guide

11.4 Heat Sink Access Panel
11.4.1 Removing the Heat Sink Access Panel
The drive has an optional access panel for accessing the heat sink. To remove or reinstall the heat sink access panel, use the
following steps. Refer to Illustration 11.41.
Disassembly
1. Do not power the drive while removing the heat
sink access panel.
2. If the drive is mounted on a wall, or its back is
otherwise inaccessible, reposition it to provide full
access.
3. Remove the internal hex screws (3 mm)
connecting the access panel to the back of the
enclosure. There are 5 or 9 screws depending on
the size of the drive.
Reassembly
Tighten fasteners according to chapter 14.1 Fastener Torque
Ratings.
1. Do not power the drive while removing the heat
sink access panel.
2. If the drive is mounted on a wall, or its back is
otherwise inaccessible, reposition it to provide full
access.
3. Fasten the internal hex screws (3 mm) connecting
the access panel to the back of the enclosure.
There are 5 or 9 screws depending on the size of
the drive.
D2h/D4h/D7h/D8h/J9 Unit Dis...
VLT
®
FC Series, D1h–D8h, Da2/Db2/Da4/Db4, E1h–E4h, J8/J9
244 Danfoss A/S © 02/2019 All rights reserved. MG94A502
1111

Danfoss VLT AutomationDrive FC 300 Series Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300 Series
Category	DC Drives
Language	English