•
•
•
-
2 Safety
2.1 Safety Symbols
The following symbols are used in this manual:
D A N G E R
Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
W A R N I N G
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
C A U T I O N
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
N O T I C E
Indicates a property damage message.
2.2 Qualified Personnel
Correct and reliable transport, storage, installation, operation, and maintenance are required for the trouble-free and safe operation
of the soft starter. Only qualified personnel are allowed to install or operate this equipment.
Qualified personnel are defined as trained staff, who are authorized to install, commission, and maintain equipment, systems, and
circuits in accordance with pertinent laws and regulations. Also, the qualifed personnel must be familiar with the instructions and
safety measures described in this manual.
2.3 Safety Precautions
Safety precautions cannot cover every potential cause of equipment damage, but can highlight common causes of damage. It is the
installer's responsibility to:
Read and understand all instructions in this manual before installing, operating, or maintaining the equipment.
Follow good electrical practice including applying appropriate personal protective equipment.
Seek advice before operating this equipment in a manner other than described in this manual.
N O T I C E
The VLT® Soft Starter MCD 600 is not user serviceable. The unit should only be serviced by authorized service personnel. Unau-
thorized tampering with the unit voids the product warranty.
W A R N I N G
PROPER GROUNDING
It is the responsibility of the installer of the soft starter to provide proper grounding and branch circuit protection according to
local electrical safety codes. Not providing proper grounding and branch circuit protection may lead to death, personal injury, or
equipment damage.
Disconnect the soft starter from mains voltage before carrying out repair work.
AQ262141844215en-000401 / 175R1174 | 9Danfoss A/S © 2020.12
Safety
VLT® Soft Starter MCD 600
Operating Guide
To Next Page
Loading...
Need help?
General
