Danfoss VLT MCD 600 User Manual

Table 50: 2-14 - Start Delay
Range
Function
* 0 s
0:00–60:00 (minutes:seconds)
Sets a delay after the soft starter receives a start command before it starts the motor.
Table 51: 2-15 - DC Brake Torque
Range
Function
* 20%
20–100%
Sets the amount of brake torque the soft starter uses to slow the motor.
Table 52: 2-16 - DC Brake Time
Range
Function
* 1 s
0:01–0:30 (minutes:seconds)
Sets the duration for DC injection during a braking stop.
Table 53: 2-17- Brake Current Limit
Range
Function
* 250%
100–600% FLC
Sets the current limit for soft brake.
Table 54: 2-18 - Soft Brake Delay
Range
Function
*400 ms
400–2000
ms
Sets the time which the soft starter waits after a stop signal is received before it begins to supply brak-
ing current to the motor. Set to allow time for K1 and K2 to switch.
10.7 Parameter Group 3-** Motor Start/Stop-2
The parameters in this group control the operation of the secondary configuration of the motor. Use the programmable input to
select the active motor set.
See 9.14 Secondary Motor Set for more details.
Table 55: 3-1 - Motor Full Load Current-2
Range
Function
Model dependent
Sets the secondary motor's full load current.
Table 56: 3-2 - Motor kW-2
Range
Function
* 0
0–9999 kW
Sets the running power of the secondary motor in kW.
Table 57: 3-3 - Start Mode-2
Option
Function
Selects the soft start mode.
*
Constant Current
Adaptive Control
Table 58: 3-4 - Start Ramp Time-2
Range
Function
*10 s
0:01–3:00 (minutes:sec-
onds)
Sets the total start time for an adaptive control start or the ramp time for current ramp starting
(from the initial current to the current limit).
AQ262141844215en-000401 / 175R117486 | Danfoss A/S © 2020.12
Programmable Parameters
VLT® Soft Starter MCD 600
Operating Guide

Danfoss VLT MCD 600 Specifications

General

Brand	Danfoss
Model	VLT MCD 600
Category	Controller
Language	English