•
•
•
•
•
•
8 LCP and Feedback
8.1 Local LCP and Feedback
READY
RUN
TRIP LOCAL
Menu
Store
Back
Reset
1
2
3
Illustration 24: Local LCP
Four-line display for status and programming de-
tails.
1
Back/Reset: Exit the menu or parameter, or cancel a parameter change. This key also resets a trip.
Menu/Store: Enter a menu or parameter, or save a parameter change.
Arrows: Scroll to the next or previous menu or parameter, change the setting of the current parameter, or scroll through the status screens.
8.2 Remote LCP
The remote LCP can be used to control the soft starter if parameter 1-1 Command Source is set to Remote Keypad.
If the remote LCP is not selected as the command source, [Start], [Stop], and [Reset] have no effect.
The menu navigation keys and display on the remote LCP are always active.
If a key is pressed on the local LCP, the display on the remote LCP updates to match.
N O T I C E
The remote LCP can be safely connected or removed while the soft starter is running. It is not necessary to remove mains or
control voltage.
AQ262141844215en-000401 / 175R117456 | Danfoss A/S © 2020.12
LCP and Feedback
VLT® Soft Starter MCD 600
Operating Guide
To Next Page
Loading...
Need help?
General
