Dell 0G8DW - Installing a Drive Blank

Figure 73. Removing a drive blank
Next step
1 Install a drive or a drive blank.
Installing a drive blank
The procedure for installing 2.5 inch and 3.5 inch drive blanks is identical.
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 If installed, remove the front bezel.
CAUTION
: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Step
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
Figure 74. Installing a drive blank
Next step
If removed, install the front bezel.
126
Installing and removing system components