Installing the WLAN
Steps
1. Slide and connect the WLAN card to the connector on the system board.
2. Connect the WLAN cables to the connectors on the WLAN card.
3. Place the metal bracket to secure the WLAN cables.
4. Tighten the M2x3 screw (1) to secure the WLAN card to the laptop.
5. Install the:
a. battery
b. base cover
6. Follow the procedure in After working inside your computer.
Memory modules
Removing the memory module
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
3. Peel and hold the label that protects the memory module to the laptop.
4. To remove memory module:
a. Pull the retention clips away from the memory module until the memory module pops out [1].
b. Pull the memory module from the memory module socket on the system board [2].
NOTE: Ensure to lift the memory module card by an angle NOT more than 35°.
20 Removing and installing components
To Next Page
Loading...
Need help?
General