2. Tighten the M2x3 screw (1) to secure the power connector port to the laptop.
3. Connect the power connector port cable to the connector on the system board.
4. Install the:
a. battery
b. base cover
5. Follow the procedure in After working inside your computer.
System board
Removing the system board
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
c. hard disk
d. memory module
e. coin cell battery
f. WLAN card
g. system fan
h. heat sink
3. To disconnect the following cables from the system board:
a. Lift the latch and disconnect the touch screen cable and display cable [1].
b. Pull the plastic label and release the I/O board cable on the system board [2].
c. Pull the label to disconnect the HDD cable on the system board [3]
d. Lift the latch and release the touchpad cable [4].
e. Disconnect the keyboard back lid cable [5].
f. Lift the latch and release the keyboard cable [6].
g. Lift the latch and release the LED cable [7]
h. Disconnect the speaker cable on the system board [8].
i. Disconnect the power connector port cable on the system board [9].
Removing and installing components
43
To Next Page
Loading...
Need help?
General