DEWESOFT Krypton - SAFE-OP state; OP state

/
KRYPTON® 
TECHNICAL REFERENCE MANUAL 


8.2.3. SAFE-OP state 
In this state the EtherCAT master is already reading the data from the slice/s at a slow sampling rate: the                    
D LED is slowly blinking. DeweSoft will set the Krypton slice/s in the SAFE-OP state when you are in                   
Channel Setup. 

SAFE-OP state 

8.2.4. OP state 
In this state the EtherCAT master is reading the data from the slice/s at the desired sampling rate: the D                    
LED is turned ON. DeweSoft will set the Krypton slice/s in the OP state when you are in Measure Mode. 


OP state 
 
KRYPTON® V20-1 110 / 141  