AT commands BLE commands
Digi XBee® 3 Zigbee® RF Module
209
204800 used
695296 free
0 bad
900096 total
FS INFO FULL
Reports every file and directory in the order they are placed in the file system along with the amount
of space they take up individually. Also reports deleted space as well as unused directory slots.
Example output:
128 /flash./
128 /flash/lib./
128 /flash/directory./
1664 [unused dir slot(s)]
2048 /flash/file1.txt.
2048 [deleted space]
2048 /flash/directory/file2.txt
FS FORMAT confirm
Formats the file system, leaving it with a default directory structure. Pass the word confirm as the
first parameter to confirm the format. The XBee Smart Modem responds with Formatting... when the
format starts, and will print OK followed by a carriage return when it finishes.
FK (File System Public Key)
Configures the device's File System Public Key.
The 65-byte public key is required to verify that the file system that is downloaded over-the-air is a
valid XBee 3 file system compatible with the Zigbee firmware.
For further information, refer to Set the public key on the XBee 3 device.
Parameter range
A valid 65-byte ECDSA public key.
Other accepted parameters:
0 = Clear the public key
1 = Returns the upper 48 bytes of the public key
2 = Returns the lower 17 bytes of the public key
Default
0
Note The Default value of 0 indicates that no public key has been set and hence, all file system
updates will be rejected.
BLE commands
The following AT commands are BLE commands.
BL(Bluetooth Address)
BL reports the EUI-48 Bluetooth device address. Due to standard XBee AT Command processing,
leading zeroes are not included in the response when in Command mode.
To Next Page
Loading...
Need help?
General
