Digi XBee 3 ZigBee User Manual

AT commands Memory access commands
Digi XBee® 3 Zigbee® RF Module
230
FR (Software Reset)
Resets the device. The device responds immediately with an OK and performs a reset 100 ms later.
If you issue FR while the device is in Command mode, the reset effectively exits Command mode.
Parameter range
N/A
Default
N/A
Memory access commands
This section details the executable commands that provide memory access to the device.
AC (Apply Changes)
This command applies changes to all command parameters configured in Command mode and also
applies queued command parameter values set with 0x09 API queued command frames.
Any of the following also applies changes the same as issuing an AC command:
n Exiting Command mode with a CN command.
n Exiting Command mode via timeout.
n Receiving a 0x08 API command frame.
n Issuing a 0x08 Local AT Command API frame.
n Issuing a remote 0x17 AT Command API frame with option bit 1 set.
Example: Altering the UART baud rate with the BD command does not change the operating baud
rate until after an AC command is received; at this point, the interface immediately changes baud
rates.
Parameter range
N/A
Default
N/A
WR (Write)
Immediately writes parameter values to non-volatile flash memory so they persist through a power
cycle. Operating network parameters are persistent and do not require a WR command for the device
to reattach to the network.
Note Once you issue a WR command, do not send any additional characters to the device until after
you receive the OK response. Use the WR command sparingly; the device’s flash supports a limited
number of write cycles.
Parameter range
N/A

Digi XBee 3 ZigBee Specifications

General

Brand	Digi
Model	XBee 3 ZigBee
Category	Control Unit
Language	English