DITEC LCA85 User Manual

38
IP2371EN
9.6.1 Additional configurable SF level parameters available with →
enabled
Display Description
SP - Setting the password
ENTER UP DOWN
2”
ENTER
[esempio]
→→
/
→→→
NOTE: this can only be selected when the password is not set.
Setting the password prevents unauthorised personnel from accessing selections and adjust-
ments. You can delete the set password by selecting the sequence JR1=ON, JR1=OFF, JR1=ON.
IP - Inserting the password
ENTER UP DOWN
2
”
ENTER
[esem
p
io]
→→
/
→→→
NOTE: this can only be selected when the password is set.
When the password is not inserted, you can access the display mode regardless of the selection
made with JR1. When the password is inserted, you can access in maintenance mode.
SF - Special functions
[example]
[example]
9.6 Second level menu - SF (Special Functions)
Display Description
CU - Displaying the control panel firmware version
→→→ Release 1.1 [esempio]
ENTER
SV - Saving user configuration on control panel storage module
ENTER UP DOWN
2”
ENTER
[esempio]
→→
/
→→→
By selecting → → you can save up to 2 personalised configurations
in memory positions
and only with the storage module present on the
control panel.
WARNING: if → → is selected, no user configuration can be
saved on
and .
Selections
available
RC - Configuration loading
ENTER UP DOWN
2”
ENTER
[esempio]
→→
/
→→→
You can load the previously stored user configurations and on the memory
module of the control panel.
RL - Loading of last configuration set
→
→
2”
ENTER
the control panel automatically saves the last configuration set, and keeps it memorised in
the storage module. In the event of a fault or the replacement of the control panel, the last
configuration of the automation can be restored by inserting the storage module and loading
the last configuration set.
SF - Special functions
[example]
[example]
Release 1.1 [example]

DITEC LCA85 Specifications

General

Brand	DITEC
Model	LCA85
Category	Control Panel
Language	English