CADENCE II Fetal Monitor User Manual
- 50 -
Chapter 8 Maintenance, Care and Cleaning
8.1 Preventive Maintenance
8.1.1 Maintaining Inspection
(1) Visual Inspection
Prior to using the monitor every time, do the following inspections:
A Check the monitor and accessories to see if there is any visible evidence of damage that
may affect patient safety. Pay special attention to the cracks on the transducers and cables
before immersing them into conductive fluid.
A Check all the outer cables, power socket and power cables.
A Check if the monitor functions properly.
If any damage is detected, stop using the monitor on the patient. Replace the damage part(s) or
contact the manufacturer for service before reusing it.
(2) Routine Inspection
The overall check of the monitor, including safety check and function check, should be
performed by qualified personnel every 6 to 12 months, and each time after service.
The equipment should undergo periodic safety testing to ensure proper patient isolation from
leakage currents. This should include leakage current measurement and insulation testing. The
recommended testing interval is once a year or as specified in the institution’s test and inspection
protocol.
(3) Mechanical Inspection
1) Make sure all exposed screws are tight.
2) Check the external cables for splits, cracks or signs of twisting. Replace any cable that shows
serious damage.
3) Pay particular attention to the supply socket.
WARNING :
Failure on the part of the responsible individual hospital or institution employing the use
of this equipment to implement a satisfactory maintenance schedule may cause undue
equipment failure and possible health hazards.
8.1.2 Maintenance of the Monitor
Keep the exterior surface of the monitor clean, free of dust and dirt.
To Next Page
Loading...
Need help?
General
