QS Series Basic Operator's Guide
Using the input table
1 If the fence is not already down, click Load Sheet ( ) to
lift the rear media hold down assembly and lower the
fence.
2 Push the edge of the sheet up against the fence and
against the edge guide on the media fence.
3 Click Print ( ).
As the media conveyor belt starts, the media roller will
lower and the media fence will raise. The media will then
advance into the printer and the carriage will move to the
print position.
Printing
Each print job consists of a prepress phase and a printing
phase. During prepress, the RIP software prepares the
customer-supplied input file for the specified output size and
media. The resulting file is loaded on the printer. For more
information about preparing an input file using the RIP
software, refer to your RIP manual.
The printing phase of the job can begin when the RIP (.RTL)
input file is transferred to the printer’s Import folder.
1 Use your RIP software to create an .RTL file.
2 Transfer the .RTL file to the printer.
Copy the .RTL file over your network or write the .RTL
file to a CD or DVD and then transfer it to the printer.
3 Open the RTL file in the active image window.
4 Load your media (sheet or web).
5 Perform a startup and run a jet test.
6 Choose your print options.
7 Choose a media type or create a new media type.
8 Create a layout or queue.
9 Start the print job and observe print quality.
10 Make print option adjustments.
OMM-00038-US English-F 23
To Next Page
Loading...
Need help?
General
