QS Series Basic Operator's Guide
Always perform the lockout/tagout procedure before
performing any maintenance or repair procedure
(unless the written procedure specifically states
otherwise).
1. Rotate the main disconnect switch to the Off position.
2. Install a lock (keyed or combination) in the space provided
on the main disconnect switch.
To restore power to the printer, remove the lock and
rotate the main disconnect switch to the On position.
Main disconnect switch in the Off position
Setting the main disconnect switch to Off does
not remove power to the switch. If work must be
done on the main disconnect switch, the printer
must be removed from facility power or full line
voltage will be present.
Every two hours
1. Wipe the jet pack faces with SCAQMD maintenance fluid
and an EFI-approved wipe.
2. When you’re done, enter the date, time and your initials
in the Maintenance Log. This procedure should take about
five minutes to complete.
OMM-00038-US English-F 45
To Next Page
Loading...
Need help?
General
