Emerson PNC001-A Series User Manual

CPU Configuration 45
Section 3: CPU Configuration
The PACSystems CPU and I/O system is configured using PACMachine Edition (PME) Logic
Developer-PLC programming software.
The CPU verifies the physical module and rack configuration at power-up and periodically
during operation. The physical configuration must be the same as the programmed
configuration. Differences are reported to the CPU alarm processor for configured fault
response. Refer to the Machine Edition Logic Developer-PLC Getting Started Manual,
GFK-1918 and the online help for a description of configuration functions.
Note: A CPE020, CPE030 or CPE040 can be converted to the corresponding redundancy
CPU (CRE020, CRE030 or CRE040) by installing different firmware and moving a jumper.
Detailed instructions are included in the firmware upgrade kit for the redundancy CPU.
This Section covers:
▪ Configuring the CPU
▪ Configuration Parameters
▪ Storing (Downloading) Hardware Configuration
▪ Configuring the Embedded Ethernet Interface
3.1 Configuring the CPU
To configure the CPU using the Logic Developer-PLC programming software, do the
following:
In the Project tab of the Navigator, expand your PACSystems Target, the hardware
configuration, and the main rack (Rack 0).
1. Right click the CPU slot and choose Configure. The Parameter Editor window displays the CPU parameters.
Note: A double-wide RX3i CPU occupies two slots and can be installed in any pair of slots in Rack 0 except
the two highest numbered lots in the rack. The single-wide CPE302/CPE305 RX3i CPU requires one
slot and can be installed in any slot in RX3i Rack 0, except the highest numbered slot or slot 0.
2. To edit a parameter value, click the desired tab, then click in the appropriate Values field. For information
on these fields, refer to Configuration Parameters.
3. Store the configuration to the Controller so these settings can take effect. For details, see Storing
(Downloading) Hardware Configuration.
Note: If available, the embedded Ethernet Interface is displayed in a sub-slot of the CPU. For
configuration details, refer to Configuring the Embedded Ethernet Interface.

Emerson PNC001-A Series Specifications

General

Brand	Emerson
Model	PNC001-A Series
Category	Controller
Language	English