Emerson Process Management GmbH & Co. OHG2-4
X-STREAM Non-Incendive
Instruction Manual
HASXENE-IM-EX
12/2014
2.3 Abstract
Save operation of Emerson Process Ma-
nagement gas analyzers requires proper
installation. Therefore all procedures that are
described in this section as well as those of
the analogous sections of the accompanying
instruction manuals need to be followed
strictly.
2.4 Installing the Analyzer
Before mounting the instrument, verify that the
installation site of the instrument is determined
adequately by means of Fig. 2-2 or Fig. 2-3.
Mount the analyzer to a stand or a wall by
means of 4 mounting brackets, provided at
the instruments rear side.
It is recommended to mount the analyzer in an
upright (vertical) position; other orientations
may affect the measuring results.
2.3 Installation - Analyzer
All dimensions in mm
[inches in brackets]
Cable glands
Gas fi ttings
Connector
for potential
equalization
Fig. 2-2: X-STREAM XEFN - Dimensions
To Next Page
Loading...
Need help?
General
