EasyManuals Logo
Home>Epson>Printer>Mobilink TM-P80II

Epson Mobilink TM-P80II User Manual

Epson Mobilink TM-P80II
113 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #100 background imageLoading...
Page #100 background image
100
Appendix
Electrical Characteristics
1: Charging time is the measured time from approximately 0% remaining charge to fully charged under the
following conditions.
The battery is new.
The printer is powered off.
Normal temperatures are defined as approximately 10 to 30°C {50 to 86°F} and low temperatures as
approximately 0 to 10°C {32 to 50°F}.
2: The test conditions are as follows.
The battery is new.
The battery is fully charged.
Printed pattern is ANK 48 digits (Font A), 20 lines + paper feed by 6 lines.
Printed once every five minutes.
Performed under normal temperature of 25°C.
Print density is 100%
Access point used is CISCO AIR-LAP1142N-P-K9
Wireless communication conditions: beacon interval is 200 ms, DTIM interval is 1, no broadcast
The time it takes for the battery to go from fully charged to approximately 0% (E level).
The power saving mode can be set in "Wi-Fi" - "Energy Saving" of the TM-P80II Utility or TM Utility.
Item Specifications
Dedicated
battery
(OT-BY80II)
Model: D241A Rated voltage: 7.2 VDC
Capacity: Typ. 1950 mAh, Min. 1850 mAh
Approximate life span (number of charge/discharge cycles): 500 cycles
USB charging Note:
Epson cannot guarantee and is not responsible for the performance or quality of
3rd party USB charging devices. The following is provided as a starting point
reference to consider in selecting a 3rd party USB charging device.
Be sure to use Product that meets the following electrical specifications:
Minimum output 5.0 V/0.5 A
Maximum output 5.0 V/8.0 A
Be sure to use Product that meets appropriate and applicable safety
certifications, ratings and regulation, which apply in the region where the
product will be used.
For examples,
FCC Part 15 compliant
UL/CSA/TUV/ISED/CE/PSE/BIS/CCC etc.
When charging the printer, be sure to use the included USB Type-C cable.
Charging time
*1
5 V/3 A At normal temperatures:
Approx. 2.5 hours
At low temperatures:
Approx. 5 hours
5 V/1.5 A At normal temperatures:
Approx. 4.5 hours
At low temperatures:
Approx. 8.5 hours
5 V/900 mA
5 V/500 mA
At normal temperatures:
Approx. 15 hours
At low temperatures:
Approx. 29.5 hours
Continuous
operating time
*2
Wi-Fi model When the power save mode is enabled:
Approx. 25 hours
When the power save mode is
disabled:
Approx. 13 hours
Bluetooth model Approx. 47 hours
Note that the above continuous operating hours may vary depending on the operating environ-
ment and other factors.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson Mobilink TM-P80II and is the answer not in the manual?

Epson Mobilink TM-P80II Specifications

General IconGeneral
BrandEpson
ModelMobilink TM-P80II
CategoryPrinter
LanguageEnglish

Related product manuals