42
Chapter 2 Setup
Installing or Replacing the Roll Paper
Follow the steps below to install or replace the roll paper.
1
Open the roll paper cover.
U"How to Open the Roll Paper Cover" on page 40
2
Remove the used roll paper core if any.
3
Install the roll paper in the correct direction.
4
Pull out some paper, and close the roll paper cover.
U"How to Close the Roll Paper Cover" on page 41
• Be careful not to touch the manual cutter when installing or removing the roll paper. The
manual cutter may injure your hand.
• Make sure you use a specified roll paper type.
• Before installing the roll paper, take up any slack in the roll paper by pulling its leading edge. If
you install a slack roll paper, a paper jam or print quality problems may occur.
• Before installing the roll paper, make sure that the roll paper is not deformed. Using a deformed
roll paper will cause the printer to malfunction.
To Next Page
Loading...
Need help?
General
